Плата тревожных входов LNL-1100-S3
The Lenel® Input Control Module (ICM) provides the access control system with high-speed acknowledgment of critical alarm points in monitored areas. The ICM communicates directly with the Intelligent System Controller (ISC) either by 2-wire or 4-wire RS-485 communication. The ICM has 16 configurable input control points and 2 output control relays. It supports normally open, normally closed, supervised and non-supervised circuits.
The input circuits are scanned using an analog-to-digital converter. The digitized input status signal is software-monitored and controlled, so that each input point can be programmed as a supervised or non-supervised alarm point. The output relays can also be configured for fail-safe or fail-secure operation. Each relay supports the “On,” “Off,” and “Pulse” Lenel OnGuard® software commands.
- Grade B, A, and AA line supervision
- 12 or 24 VDC input power
- 16 programmable supervised or non-supervised contacts
- 2 Form-C 5 A, 28 VDC contacts for load switching
- 2 dedicated inputs for tamper and power failure status
- On-board termination jumpers
- DIP switch-selectable addressing
- Elevator control, support for 128 floors
- Status LED for host communication and heartbeat
- Variable resistor values for line supervision
- Downloadable firmware
LNL-AL400ULX Lenel UL Listed 4A, 110VAC Power Supply – 12VDC 4A output, 115VAC input, continuous supply current with enclosure (15.5” x 12.5” x 4.5”), lock, tamper switch, UPS capable (Battery Optional) UL & CUL Approved
LNL-AL600ULX-4CB6 Lenel UL Listed Power Supply – 12VDC 6A output, 115VAC (1.6 amps) input, continuous supply current with enclosure (24” x 18” x 4.5”), lock, tamper switch, power distribution module, UPS capable (Battery Optional) UL & CUL Approved
ABT-12 Battery Kit - 12VDC, 12 AH battery (PS-12120)
| Название характеристики | Значение |
| Primary Power | 12 to 24Vdc ±10%, 350mA maximum 12Vdc @ 300mA nominal, 12.27 BTUs 24Vdc @ 220mA nominal, 18.00 BTUs |
| Outputs | 2 outputs, Form-C, 5A @ 28Vdc, resistive |
| Inputs | 16 unsupervised/supervised, standard EOL: 1k/1k ohm, 1%, 1/4 watt 2 unsupervised, dedicated for cabinet tamper and UPS fault monitoring |
| Mechancial | Dimension: 6” (152mm)W x 8” (203mm)L x 1” (25.4mm)H Weight: 9 oz. (250 g) nominal |
| Environmental Temperature | Operating: 32°F to 158°F (0°C to +70°C) Storage: -67°F to 185°F (-55°C to +85°C) |
| Humidity | 0% to 95% RHNC |
| Compliance Approvals | FCC Part 15, CE, RoHS, UL 294, UL 1076, ULC CSA-C22.2, CAN/ULC-S319-05, cUL/ORD-C1076 |